Used! Dies Watch Case Back Opener Kit Fit For Breitling Watch Removal Repair Tool

DIES WATCH CASE BACK OPENER KIT FIT FOR BREITLING WATCH REMOVAL REPAIR TOOL. NOTE:Just one scratch on the cover, there is no problem on other parts, won't be any influence on using. Plz check last two pictures for reference. Looking do business with someone who don't mind. 15 Dies case back cover opener kit for bottle opener removal repair tool. Made of high-quality stainless steel with aluminum handle and 15 stainless steel molds. It can be used to open other cases of expensive watches. Bre 1: 19.12mm Bre 2: 23.45mm Bre 3: 25.90mm Bre 4: 26.00mm Bre 5: 26.75mm Bre 6: 26.80mm Bre 7: 29.5mm Bre 8: 33.36mm Bre 9: 34.60mm Bre 10: 35.75mm Bre 11: 36.03mm Bre 12: 36.8mm Bre 13: 37.7mm Bre 14: 42.02mm Bre 15: 43.72mm. How to remove the watch band. Make sure you are on a flat surface (table or table). Place the watch on a cloth or towel to avoid scratching. Press one end of the spring rod from the back of the watch, use the "spring rod remover tool", and use the spring rod to remove the fork (fork) end of the tool between the lug and the strap. The spring rod removal tool has a tool that will grab the ridge and allow it to compress. Apply a slight pressure to the strap (away from the lug) to depress the spring lever.

At the same time, applying some downward pressure, the spring rod will pop out. Once again, you just took the table band from the case. How to install the strap. Insert the spring strips into the holes on both sides of the belt.

Push them all in and center them inside the strap. Install the short end of the strap (the side of the buckle is at 12 o'clock). Insert the end of the spring rod into the hole in the case lug from the back of the watch. Use the spring lever removal tool (forked "fork" end) to press the other end of the spring rod into the hole in the lug.

Make sure that both spring bars are in their holes by pulling them slightly, or that the straps are coming off the watch. Give it a little drag to make sure it is safe.

Repeat the above steps on the other side. The long end of the strap (with holes) is at 6 o'clock. 1 set of case back bottle opener kit (15 molds). Feedback is very important to us.

It is impossible to address issues if we do not know about them! Faction is our ultimate goal. We work hard to earn your trust and future business. A If you receive a defective item, you may return it or ask for a discount.

Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday. This item is in the category "Jewelry & Watches\Watches, Parts & Accessories\Parts, Tools & Guides\Tools & Repair Kits". The seller is "acetool2007" and is located in this country: US. This item can be shipped to United States, Poland, Ireland, Netherlands, Slovakia, Slovenia, Sweden, Belgium, Italy, Republic of Croatia, Portugal, Australia, Austria, Bulgaria, Czech Republic, Greece, United Kingdom, Hungary, France, Denmark, Spain, Estonia, Monaco, Romania, Lithuania, Finland, Luxembourg, Germany, Latvia.

Item location: CA /NJ /Austell
Type of Tool: Case Opener
Shipping notice: Can not ship to Puerto Rico/Alaska/Hawaii
Brand: Unbranded
Country/Region of Manufacture: China