1pc Dent Lifter 5pcs Tap Down. 1pc Metal Tap down with 9 heads. 20pcs Pro Tabs 1pc T-bar. 1pc Bridge Puller with 7 Pulling Tabs. 1pc tool bag 1pc bottle.
Find the dent by the line board (through the refraction of light)and clean it with rag and alcohol. Then clean the glue stick with alcohol to remove the grease on its surface. Insert the glue into the glue gun and connect the gun to the power supply, then heat it about 2-5 minutes until there is some hot glue spilling out from the gun.
Choose a tab whose shape is the most similar to the dent and pay attention to the hot glue which should begin from the centre of the tab, and with the circle action to smear it cover the tab, but should not overstep. The tab bigger the traction stronger, so if the dent is big, you should choose a big tab. You should quickly paste the tab to the dent and press it until the hot glue is firmed. Fasten the Dent Lifter or T-shaped Repairer or Hammer or Bridge Puller and hold its two handles, up and down with power gradually, repeat your action until the dent is repaired or flatted, and don't let the tab go off the car body.
What's more, you should pay attention to your power and not be rushed. After repaired, spray the adhesive remover on the part where covers glue and remove it with a scraper. Check the repair effect again, if not very well, please repeat the above steps until be repaired. DIY is much cheap than body shop.
There are 21 Pieces different Blue Rods. The tails have 21 kinds of shapes. The materials is stainless steel, won't easy to bent and rust. Convenient for different dents in different parts of a car. The handles are easy to use and convenient to operate.
WHDZ Line Board - Check the dent when you're not sure where is the dent. Metal bridge dent puller :made of environmental metal material.
7 pulling discs: screws were enough long just easily fix dent of all size. Glue gun: 100w glue gun melting glue stick is more faster and this glue gun not only use for repair dent but also adhesive art products. The reflection becomes distorted where the dent is and you can then work your tool behind the dent to make the distorted image even or uniform again, once the distorted image or lines become parallel in the reflection you have successfully removed the DENT! Convenient when working outside with a natural light.
Size: 30cm 21cm; Steady suction arm with a powerful cup for 360 any angle. The Red dent lifter is designed to remove small dents and hail damage. Made from light weightaluminum then powder coated. Padded feet add support for maximum pulling power while not denting surrounding areas. Hand unit allows for controlled leverage while removing dents.This item is in the category "eBay Motors\Automotive Tools & Supplies\Automotive Repair Kits\Dent Repair Kits & Tools". The seller is "westworldwest" and is located in this country: US.
This item can be shipped to United States.